Description

Heat Shrink Ring Terminal — 8 AWG, 1/4″ Stud, 25-Pack

Terminate heavy-gauge wiring at panel-size studs with a fully sealed, corrosion-proof connection. These adhesive-lined heat shrink ring terminals combine an 8 AWG tinned copper crimp barrel with a dual-wall heat shrink sleeve — delivering a watertight termination at 1/4″ studs for high-current circuits including bilge pumps, windlasses, solenoids, and heavy accessory feeds routed to distribution panels.

Key Features

• Dual-Wall Adhesive-Lined Heat Shrink — Inner adhesive melts and seals the crimp zone during heating, locking out moisture and preventing galvanic corrosion at the wire-to-terminal interface
• 8 AWG Heavy-Gauge Rating — Handles the current demands of windlasses, thrusters, bilge pumps, inverters, and other high-draw accessories
• 1/4″ Stud Size — Fits the 1/4″ (#10) studs on fuse blocks, distribution panels, solenoid terminals, and circuit breakers where heavy-gauge feeds terminate at panel-size hardware
• Tinned Copper Barrel — Corrosion-resistant construction maintains low contact resistance and long-term conductivity in salt and humid marine environments
• Closed-Ring Design — Ring cannot back off the stud under vibration, ensuring a permanent, secure connection at critical high-current points
• 25-Pack Quantity — Covers a full wiring project or keeps your onboard spares kit well stocked

Specifications

• Type: Heat shrink ring terminal (adhesive-lined, dual-wall)
• Wire Gauge: 8 AWG
• Stud Size: 1/4″
• Barrel: Tinned copper
• Sleeve: Dual-wall adhesive-lined heat shrink
• Quantity: 25 per pack
• Application: High-current accessory feeds, solenoids, fuse blocks, distribution panels, bilge pumps, windlasses
• SKU: 1385313

8 AWG Heat Shrink Ring Terminal — Stud Size Comparison

• 8 AWG, 1/4″ stud — Heavy-gauge wire to panel-size fuse blocks, solenoids, circuit breakers (this SKU — 1385313)
• 8 AWG, 5/16″ stud — Heavy-gauge wire to battery posts, main bus bars, large solenoids (SKU 1385348)

Both use the same 8 AWG wire gauge — choose based on the stud size at your termination point. Measure the stud diameter or check the terminal block spec before ordering.

Installation Notes

Strip 8 AWG wire to the correct length so the conductor fills the barrel without protruding. Use a heavy-duty ratcheting crimper rated for 8 AWG — light-duty crimpers will not produce a reliable gas-tight crimp at this gauge. Apply heat evenly with a heat gun until the sleeve shrinks uniformly and adhesive flows from both ends. Allow to cool fully before torquing the stud nut to the terminal block manufacturer’s specification. Do not use an open flame — it damages the sleeve and conductor insulation.

The 1385313 bridges the gap between heavy-gauge wiring and panel-size hardware — the right terminal when your 8 AWG run needs to land on a 1/4″ stud with a fully sealed, vibration-proof connection.