Description

The Seaview AMA-W adjustable wedge is designed to level Seaview low-profile satdome or dome adapter installations on sloped mounting surfaces such as radar arches, hardtops, cabin tops, and custom electronics mounts. It uses two concentric rotating wedge halves to provide 0° to 12° of angle adjustment, helping the dome sit level even when the mounting surface is not. Seaview lists the AMA-W for low-profile adapters and mounts with an 8″ round base.

Key Features

• Adjustable wedge for Seaview low-profile dome / satdome adapters
• Provides 0°–12° of leveling adjustment
• Designed for sloped hardtops, radar arches, and cabin-top installations
• Works with Seaview low-profile adapter models including AMA-16, AMA-18, AMA-18IP, AMA-24, AMA-32, and AMA-GXF
• Also referenced for Seaview mounts with an 8″ round base
• Diameter: approximately 7.9 in.
• Height at 0° adjustment: approximately 1.09 in.
• Weight: approximately 3 lb
• Seaview part number: AMA-W / AMAW
• Barcode / UPC reference: 839662002653

Application Compatibility

This wedge is intended for Seaview low-profile dome adapter installations where the mounting surface needs angle correction. It is commonly paired with Seaview AMA-18 and AMA-24 low-profile satdome mounts for 18″ and 24″ dome applications, and also fits other compatible AMA-series low-profile adapters and 8″ round-base Seaview mounts.

Fitment Notice

This is a mounting accessory, not an engine-specific part. Before ordering, confirm the Seaview adapter or mount model, dome size, mounting surface angle, bolt pattern, cable routing, and available installation clearance. The AMA-W is the wedge only; dome adapters, mounts, hardware, and electronics may be sold separately depending on the installation.

When This Part Needs Replacement

Replace or add this wedge when a dome or satdome mount cannot sit level on a sloped surface, when an existing wedge is cracked or damaged, or when upgrading a dome installation on a radar arch or hardtop that requires angle correction.

Installation Notes

Install the wedge beneath the compatible Seaview low-profile adapter or 8″ round-base mount. Rotate the two wedge halves until the correct leveling angle is achieved, then confirm the dome sits square and level before final tightening. Check cable routing through the mount and make sure the finished installation has proper support, sealing, and clearance for the electronics being installed.

Alternate/Superseded Part Numbers

• Seaview AMA-W
• Seaview AMAW
• SVW-AMA-W
• SVW AMAW
• AMA-W Adjustable Wedge
• Adjustable Satdome Wedge for Low Profile Mounts
• UPC: 839662002653

Parts Desk Insight

This is the part that cleans up a dome install when the hardtop or arch is not flat. The mount may fit the dome perfectly, but if the base is sitting on a slope, the AMA-W lets you level the finished installation without building a custom shim.

Shipping: Ships same or next day for fast Canada wide shipping.